Before trimming the guide tube of the da Vinci Mini, you need to unload the filament. Instructions for this can be found in the link below:
In the printer monitor panel, click Setup > Jog Mode.
Make sure the extruder module has returned to the home position.
Remove the guide tube from the feed module.
Push down on the black ring on the feed tube grip and pull out the feed tube.
Remove the guide tube from the extruder module.
Push down on the black ring on the feed tube grip and pull out the feed tube.
Prepare the following:
- Feeding path cleaning wire
- Diagonal pliers
- Scissors
Insert the feeding path cleaning wire into the guide tube.
Use the pliers to cut the guide tube cleanly.
Remove the feeding path cleaning wire from the guide and reinstall the guide tube.
Note: If the guide tube is under 50cm, we recommend that you replace it.
