Pen Holder

Use the software’s various 3D libraries to decorate the pen holder. In the left-hand model toolbar, click on Letters, then click on the “next page” icon.   Single click on H and the character “H” will follow your cursor on the screen. Move the cursor to the front of the pen holder and click again on either the left or right mouse button to place the “H” character. Tip: If you accidentally select an object from the 3D library, click in the modeling grid to place the object and then press delete or undo.   Repeat the steps above to make H, a, p, p, y on the modeling grid.   Select any character, then hold down the (ctrl) key and select the remaining four characters.   Change your viewing angle as shown above. Click and hold the rotation arrow above the Y axis, then with the mouse button still

In the model toolbar, click on the crown icon (Special), and select the XYZprinting logo.   When you single click on the XYZprinting logo, the part will follow your cursor in the modeling grid. Left/right mouse click to place the logo in front of the pen holder.   If the part is too small and it’s hard to edit the control points, you can use the Properties window to enlarge the part’s dimensions first. Select the XYZprinting logo and in the Properties window click on the Lock icon.   In the properties window, change the X axis dimension to 70mm, all other axis will scale accordingly.   Take the XYZprinting logo and move it to the same position as above.   Inspect the model to any modeling errors. In this example the XYZprinting logo has passed through the other side of the pen holder.   Click on the control orb’s