Attach the extruder module to X-axis
Clip the extruder module into the extruder module mount on the X-axis.
Insert ribbon connector to extruder module>
Plug the ribbon connector into the housing located on the extruder module
Insert the power cord
Attach the power cord to the power adapter and plug the power adapter into the da Vinci Mini.
Attach guide tube to feed module and extruder module
After ensuring the guide tube is properly connected to the feeder module, take the other end and feed it through the top of the printer, then insert it into the extruder module.
Attach bed tape to print bed
Unpeel the bed tape and smoothly apply it to the print bed.
Open spool holder case
Pull down spool holder
Place assembled filament spool on spool holder
The white filament spool ring comes pre-assembled with your complementary filament. When you purchase new filament you will need to transfer this part to the new filament spool before using it.
Cut filament at 45°
Pull the lever and insert the filament through feed module
Make sure that is passes through the feed module and can be seen in the guide tube.
