Author / uitester

by uitester

Hardware Setup

Attach the extruder module to X-axis

Clip the extruder module into the extruder module mount on the X-axis.
Hardware_1

Insert ribbon connector to extruder module>

Plug the ribbon connector into the housing located on the extruder module

Hardware_001

Insert the power cord
Attach the power cord to the power adapter and plug the power adapter into the da Vinci Mini.

Software_003

Attach guide tube to feed module and extruder module

After ensuring the guide tube is properly connected to the feeder module, take the other end and feed it through the top of the printer, then insert it into the extruder module.    

Hardware_002

Hardware_004

Attach bed tape to print bed

Unpeel the bed tape and smoothly apply it to the print bed.
Hardware_005

Open spool holder case

Hardware_006

Pull down spool holder

Hardware_007

Place assembled filament spool on spool holder

The white filament spool ring comes pre-assembled with your complementary filament. When you purchase new filament you will need to transfer this part to the new filament spool before using it.

Hardware_008

Cut filament at 45°

Hardware_009

Pull the lever and insert the filament through feed module 

Make sure that is passes through the feed module and can be seen in the guide tube.Hardware_010

Hardware_011

 

by uitester

Unboxing

Open box and remove accessories

Remove the accessories and foam block covering the da Vinci Mini and place them to one side.  

Note: Keep the original packaging materials in case you need to send your unit back for repair during the warranty period. If other packaging materials are used instead, the printer may become damaged during transportation. In such a situation, XYZprinting reserves the right to charge a repair fee.

unboxing 2

Check that all accessories are there

Confirm that the accessories are there by checking the image below.

contents1-02-01

 

Remove da Vinci Mini from box

Take the da Vinci Mini out of the box and place it on a stable surface.

unboxing 3

Take out the folded cardboard

Remove the folded cardboard, being careful not damage the extruder module mount.

unboxing 4

Remove red and transparent tape

Remove all red and transparent tape from the da Vinci Mini.

unboxing 5

Remove 4 shaft clips

There are 4 orange clips attached to the Mini’s Z-axis shaft that support the X-axis and extruder mount. These need to be removed before operating the machine or it will not move when turned on.

unboxing 7-01
unboxing 6